Over the years a number of people have attempted to make replacement landing gear springs for the Jungmann. Some have worked for a while, then sagged, others have not had quite the right combination of spring rate and damping. The springs made by Gary Hickman, however, have been very satisfactory. A lot of research and engineering has gone into making these springs. The first batch of 20 sets having sold out, Gary has produced a second batch which he says are "even better":
New Bucker landing gear springs. Solve your sagging springs problem. These work and last landing after landing! Professionally engineered and manufactured.
- Made from Chrome Silicon Wire
- Shot Peened
- Stress Revieved
- Heat Treated
- Wire Diameter - .327” (8.3mm)
- Outside coil diameter – 1.668” (42.36mm)
- Inside coil diameter – 1.02” (25.9mm)
- Free Length 21” (533.4 mm)
Will fit all original Bucker landing gear strut tubes. Single gear spring configuration (no spacers required). Note: Will not fit Krybus or Charlie Miller landing gear struts
$600 per set of 2 springs
Contact Gary Hickman (OWNER: BUCKER JUNGMANN N1947H)
Edge Engineering
www.edgecnc.com
(619) 456-4564